When cleaning your pool, you may encounter a number of issues, such as your pool vacuum being stuck in the drain. To remove dirt or debris from the pool, the pool vacuum generates suction. However, it is not uncommon for the vacuum to get overly powerful and become trapped on your main drain. As a result, you must understand what causes the pool vacuum to become stuck and how to keep pool vacuum from getting stuck on drain.
Why does the pool vacuum get stuck on the main drain?
The pool vacuum might become stuck on the pool main drain for a variety of reasons.
The pool’s bottom shape
The pool vacuum can become stuck if the angle of the pool bottom relative to the pool drain varies slightly. After the pool has been replastered, the pool vacuum generally becomes stuck. In truth, a certain pool vacuum does not get stuck in all pools with the same pool vacuum and drain cover combination. This indicates that the form of one pool bottom differs from another, causing them to become stuck.
The suction balance
The suction balance occurs between the water flowing through the pool drain and the water flow through the pool vacuum. When water flows through both the pool drain as well as the pool vacuum simultaneously, a suction force is generated between them, and the vacuum may not have enough onward force to overcome the suction lock, resulting in the vacuum becoming stuck. As a result, you must lower the suction force by regulating the water flow so that the majority of the water flows through the vacuum rather than the drain. This will increase the vacuum’s forward force, allowing it to escape the drain.
The vacuum condition
Your pool vacuum itself might cause them to become stuck, therefore, you should check the condition of your pool vacuum on a frequent basis. Although they normally perform well, your pool vacuum will require maintenance over time. When the suction parts wear out, the vacuum will be more likely to become stuck on the drain.
How to keep pool vacuum from getting stuck on drain?
While you may be aware of the factors that cause this, you should also be aware of how to keep pool vacuum from getting stuck on drain. You may use these suggestions to help you avoid this situation.
Adjusting the flow of water
You must change the water flow in order to change the suction. The more intense the water flow, the more likely it is to become trapped in one spot. If you don’t have enough suction, though, the cleaning will be ineffective. In most cases, the water that returns to the pool after pumping does not obstruct the pool vacuum’s original direction.
You may reapply hydraulic pressure to an area where the vacuum is stuck to assist in pulling the hose out of the corner, allowing the vacuum to clean the pool more effectively but also putting additional wear on the vacuum’s head.
The hose’s overall length
You must select the appropriate vacuum hose for your swimming pool based on its size and shape. The length of the hose is usually computed by adding the size of the skimmer baskets by one meter from the pool’s furthest border. You may eliminate the chance of the pool vacuum being stuck on the drain by using the correct length.
The weights for the hose
Hose weights are used to keep the head of the pool vacuum balanced on the pool surface. The majority of people wrongly set the hose weights at the top. On the contrary, you must understand where the hose weights should be placed appropriately. The weight of your hose may be properly placed to prevent it from being stuck.
The storage for the hose
It’s best if you remove them and line them up straight next to each other. If you don’t have adequate storage space, avoid storing the hoses on a rough surface. They may curl as a result of this. If a segment of the hose is looped, the pool vacuum can easily become stuck.
Summary
To summarize, you must understand how your pool vacuum works in order to know how to keep pool vacuum from getting stuck on drain. You must pay close attention to the water flow, the hose, and the main drain.
