Pool owners or cleaners normally require a pool vacuum to keep the pool clean. A pool vacuum is a gadget that can assist in the effective cleaning of a swimming pool. A pool vacuum is made up of various components, including a footpad, diaphragm, hose, and many others. The pool vacuum hose is a flexible hollow tube used to transport water from one location to another. To clean a pool effectively and correctly, you must also understand how to use pool vacuum hose.
Choosing a pool vacuum hose
Before cleaning your pool, make sure you have the proper pool vacuum hose. You will be able to pick your preferred vacuum hose based on several aspects after reading this page.
The hose’s total length
The first step is to measure the distance from the skimmer box to the farthest point of your pool, plus an extra 1 to 2 meters. However, if you have a suction cleaner with a diaphragm of Kreepy Krauly VTX7, you will need an extra 2 meters in length since they will circle the hose. The added length of 1 meter or 2 meters increases the likelihood of it reaching all areas in your pool.
The hose’s flexibility
This is also a significant consideration. The suction cleaner’s pattern will be influenced by the hose. A stiff vacuum hose will reduce flexibility and performance. The cleaning pattern will be patchy. Therefore, you need to choose a flexible hose.
The continuous or sectional hose
You must have a preference in order to choose this factor. You do not need to straighten the sectional hose before utilizing it. It is also simple to replace a specific part of the hose rather than the continuous hose when it breaks. Nonetheless, due to the many connections, the sectional hose has a somewhat slower flow than the continuous hose. Debris between each connection also might occasionally cause blockages.
On the other hand, the continuous hose must be straightened before each use. Blockages can still occur, making the cleaning procedure much more difficult.
How to use pool vacuum hose?
After deciding on the best pool vacuum hose for your needs, you must understand how to use pool vacuum hose to clean your swimming pool.
Connect the vacuum head to the hose
Before cleaning, switch off your pool filtration system and attach the vacuum head to the open end of the telescopic pole. Connect one end of the hose to the vacuum head as well.
Take the air out of the hose
There are two techniques for removing air from your pool vacuum hose. The first method is to drop the other end of the hose into the pool and keep it there until the bubbles cease.
The second approach is to utilize the pool’s return jet to force air through the hose. After removing the air from the hose, take the loose end of the hose from the pool and lower it to the main drain area. The will generate a high-pressure suction, allowing you to begin cleaning.
Connect the hose to the pool
You need to connect the skim vacuum plate to the end of the hose. Bring your hand over to the skimmer and close the aperture. Remove the skimmer basket inside if you are not using the vacuum plate. Block the end of the water-filled hose with your hand. Then, connect the hose to the skimmer’s inlet.
Begin at the deepest point
You should begin at the deep end of the pool. This is where debris normally accumulates. You must use the telescopic pool pole to sweep the hose back and forth across the pool’s bottom at a smooth and steady pace. You don’t want to overdo it since it will mix up the debris even more. After the deepest section, you can gradually move to the shallow area.
Unplug the vacuum cleaner
After vacuuming the pool, remove the head from the telescopic pole and drain any remaining water in the suction hose. Attach your cleaning brush to the pole and scrape any dirt or debris from the pool’s sides. You also should clean the pump strainer basket, test your pool water, and wash all of your equipment with fresh water. This action concludes your understanding of how to use pool vacuum hose to clean a pool.